Black Friday Christmas Sale — up to 50% OFF
Free shipping over $99
Order now, delivered before Christmas
SPRIG

Setup

Fluffing a pre-lit tree in twenty minutes

Every artificial tree arrives flat. The difference between a tree that looks like the photo and one that looks like a bottle brush is the next twenty minutes.

2 min read

Start at the bottom, one section at a time

Set up only the bottom section first and plug it in so you can see the lights while you work. Fluff it completely before you add the next section. Working top-down means reaching through finished branches and flattening them again.

Each branch, three directions

  • Pull every tip on the branch apart into a fan: one tip up, one tip left, one tip right
  • Work from the trunk outward, so the inside of the tree is full and you cannot see the pole
  • Bend the very end of each branch up slightly so the tree reads as full from across the room

Hide the lights, do not fight them

The bulbs are already wired along the branches. Fluff around them and tuck any wire that shows deeper toward the trunk. If one area looks dark, it is usually a branch that was not fanned out enough to show its bulbs.

Gloves and a playlist

The tips are stiff and you will touch a few hundred of them. Thin garden gloves save your hands. Most full 7.5 ft trees take two people twenty to thirty minutes; you only do it once, because the shape holds year to year.

Will the branches keep their shape next year?

Mostly. Store the tree in a bag or its box without crushing it and the second fluff takes half the time.

Should I fluff before or after adding ornaments?

Before. Ornaments hang from fluffed tips; on flat branches they slide to the trunk.

Shop the guide

Mentioned in this guide

Keep going